DrewNJ2FL
Fabricator/Welder/4x4 Tech needed
No cutting out parts with a torch here. CNC cut parts done in house. Need someone to install lift kits and accessories as well as help assemble and weld our 4-Link kits. I don't need a backyard mechanic or someone who just went to welding school. Must have some experience and a ride to work and be able to work late once a week. $15-$25 per hour depending on your skill level, experience, and tools. The understanding of suspension and steering geometry would be a bonus.

We do straight axle conversions, 1 ton conversions, full 4-Link/5-Link coil-over conversions as well as 2.5 ton builds.
Also a lot of ball joints, bearings, and front end work.

Contact Drew at Autotech4x4. 561-267-0649 text or call
eMail resume to Autotech4x4@Gmail.com if you have one.
Autotech4x4 ...Fabrication,CNC cut parts, steering and suspension geometry, 4 Link suspension and tube frames, Custom rims & centers, Diesel performance and repair.
Quote 0 0
Chevy_mud_truck
This is the job I need now if I had the money to move to Florida
Quote 0 0
DrewNJ2FL
where are you located now?
what is your skill level with fabrication and suspension geometry?
Autotech4x4 ...Fabrication,CNC cut parts, steering and suspension geometry, 4 Link suspension and tube frames, Custom rims & centers, Diesel performance and repair.
Quote 0 0
Chevy_mud_truck
West Virginia
I can weld and fab do just about any kind of repairs on any make of vehicle just finished a turbo on a duramax Friday put a leveling kit and two complete stereo installs I've installed around six to eight hundred lift and leveling kits done motor swaps transmission swaps axle swaps brakes ball joints
Just know the bare basics on suspension geometry
Quote 0 0
http://www.bigshocks.com/" target="_blank">